Separate names with a comma.
I'm trying to split my engine case and remove the crankshaft, and I think I have one crankcase bolt left behind the magneto housing. I can't get...
I'm looking at the bottom end of my spare 3LN engine, and can't work out where the oil restrictor is. Anyone got a picture of what I need to be...
Unfortunately you appear to be right. Stripped it down today and cylinder 3 piston is loose and the bearing looks melted at some points. Must have...
Was out riding my bike today, having no real issues. Had to get up to 100km/h so I took it up to around 15k RPM and it started to struggle, from...
Had a look at the exup and it seems that the cables were on backwards, so that is all lined up properly now. Running much better at idle and lower...
91 RON, although there is a bit of 98 in there at the moment and it didn't seem to make much difference between the two
From memory I removed the pump and it seemed to run a bit better when I was having a lot of problems a while ago. I can try refit it and see if it...
Finally got my bike running and out on the road after a lot of screwing around. Now I'm just sorting out some little issues. The bike doesn't seem...
Thought I should update this. Bike seems to run better now. It actually moves so thats a start. I think it was due to the plugs needing cleaning,...
Ok I think I will check the tank next. Forgot to mention that I did change the filter, and the fuel pump seemed to be causing issues, so I...
Having the worst luck with this bike. My 3ln fzr250 starts, idles, revs fine in neutral, however it just dies whenever I try to ride it. It seems...
Well I pulled the cam out and took out the buckets. What do the shims look like? Inside the bucket there is a small round bit of metal. Seems to...
Been having some trouble getting my bike to start and run, mainly when its cold. I just checked the valve clearances but am not sure what to make...
Put a new engine in my bike recently, noticed it has a clutch issue. If I put the clutch in with the bike running, and select first, 90% of the...
Well I'm making progress with it. I replaced the leads today, and gave the spark plugs a good clean. Seems to be running a lot better. I could get...
Looks like a couple of the ignition leads could be buggered. Any idea if these are easily replaceable, or leads off another model could be used?
My headache continues. I got the bike running with a new fuel filter, so fuel pump is working wine. Must have just been clogged. Still can't get...
Hmm air leak would make sense. I will look for that next. I also believe I have found some problem to do with the fuel filter/pump. I could get...
Well I had some success. The floats all go up to the float level mark also. I got the bike to run, without any starting spray or propane, etc....
Yeah I tried each spark plug against a screw driver and they all had a spark. Not sure if it was a strong spark but it was there. Had a feeling my...