Separate names with a comma.
This hose pops out after engine heat up enough (Water temp ~90C) , re-tighten the worm clamp and still cant find enough grip. Is it time to change...
I was trying to start up my bike after it sits for a few months or so. Charged up battery, cleaned carburetors, make sure fuel flows, got spark...
took apart the petcock and found a busted diaphragm [ATTACH]
Notice a puddle of gasoline on the floor while idling the bike, took a closer look and saw fuel literally spraying from petcock area. Checked...
Found out R25 v2 has 65mm plates, will try once I get it [ATTACH]
Hi, I have measured my rearsets mounting holes center to center distance is about ~66mm, is this accurate? does anyone know which bike model have...
So theoretically, I can check my IC Igniter Pink cable to ground if it has 10K resistance means the CDI have no speed limiter?
Hi, does anyone know what is the function for this PINK cable from IC Igniter to Speedo/Indicator connectors? [ATTACH] [ATTACH]
sorry just to clarify, you cut the old timing chain and install a new timing chain??
The bolts head size is M22 confirmed by local mechanic. Anyway, I have an off topic question for you sir, since you are the owner of litetek. Is...
[MEDIA] hello guys, is this normal behavior for the drive chain? Clutch lifted and it starts to jump vigorously Experienced jerk around 3~4k RPM...
Could you help to measure?
Anyone know ZXR250 swing arm pivot bolt size on both side? from part photo can see the nut is 16mm,but what about the shaft end, is it the same?...
so what solved the jerky on low rpm?
is taking the rocker cover off required engine oil draining or is there any gasket that need to be replaced after removing the cover?
[MEDIA] I bought the Krieger instead. Not perfect fit on the base mounting but its working. the tensioner bolt a bit too long imho, I will grind...
Hi, if anyone know whether the CCT for zxr250c is the same as the 08'-11' ninja250r ? Im looking to buy the manual CCT from APE...